Quested S7R Active Studio Monitors (Pair)

Full Description

Two class A-B amplifiers capable of delivering a total of 190 Watts RMS are mated to an enclosure tuned with a double flared port designed to minimise any possible low frequency "chuffing". The result is an extremely powerful, neutral, articulate and accurate compact monitor perfect for a wide range of music styles from acoustic jazz to house.

The frequency response is more than adequate for most applications, it can however be extended down to 25Hz when coupled to the SB10R sub-woofer. The S7R is fully magnetically shielded, so can be used in close proximity to CRT monitors.

All S-Series monitors are phase coherent with each other enabling them to be used in combination in multi-channel systems

Some typical applications include components in multi-channel systems, postproduction, project studios, location recording, and mastering

Specification

• Size (WxHxD) Dimensions 244(w) x 347(h) x 302(d) mm
• Weight 11.7 kgs
• Drivers Bass cone - 1 x 165 mm (6 ½ ")
• High Frequency soft dome - 1 x 28 mm (1 ?")
• Maximum SPL 107 dB (c) continuous pink noise 1 m (119 dB (c) per pair RMS music)
• Frequency Response 65 Hz-22 kHz ± 2 dB
• Input Connector XLR and ¼ inch Jack combo socket
• Impedance 10k electronically balanced with RF filters
• Sensitivity -12 dBu to +6 dBu for 96 dB SPL 1 m set by 10 position rotary switch on rear
• Filters - Subsonic -3dB 30 Hz, 24dB/oct, Ultrasonic -3dB 75kHz, 4dB/oct,
• Crossover 1k19
• LF EQ -2/-4 65 Hz
• HF EQ +/- 2dB 10 kHz
• Power Amplifier - LF output power > 120W RMS, HF output power > 70W RMS
• T.H.D. < 0.03 at levels up to 1 dB below clip, 20 Hz-20 kHz. typ 0.005 1kHz
• Hum + Noise > -100 dB referred to clip
• Consumption - Quiescent 18W, Typical use 75W (average music), Max 140W (average music)
• Note 0 dBu = 775 mV into open circuit